A Brief Discussion on Automotive Wire Harness Adhesive Tape
Sep 27,2024
Program. Place the adhesive surface of the test sample without tension or pressure on a hard and smooth surface. Measure the width perpendicular to the edge with a steel ruler at three similar equidistant points along the length.
The analysis of the width of the wiring harness tape should be based on the following table. The deviation of width should be within ≤± 1 mm.
4. Tensile strength and elongation. The test should be conducted according to ISO 29864, except for preparing 5 samples of the same width, each sample being 200mm long. For tapes with a width greater than 25mm, a 25mm wide test sample should be cut vertically from the tape. Use a sharp knife to obtain a clean cut edge. The explanation of the test results can be found in the following table..
5. Unwinding force. The test should be carried out in accordance with EN 1944. The analysis of the test results can be found in the following table. Record the average force. Note: The unwinding force should be agreed upon between the tape supplier and the wiring harness supplier.
Related News
Versatile Uses of PVC Tape: The Unsung Hero in Everyday Life
Everything You Need to Know About PVC Tape: Tips and Tricks!
Unraveling the Mysteries of PVC Tape: Your Go-To Guide
The Magic of PVC Tape: Unraveling Its Incredible Functionality
The Versatile World of PVC Tape: A DIY Essential